Filter
Top Products
'=
,
--
Installing the Belt Clip
1. Place the Belt Clip on
the mounting area on
the back of the
scanner, making sure
the holes in the clip
line up with the
threads in the back of
the scanner.
~ ~
@@
~
I
2. Insertthe 2 screws into the corresponding holes and
tighten.
CAUTION: Do not tighten the screws too tight. You could
damage the case or clip.
Using the Earphone
The PHONEjack at the top of the UBC 120XLT is a standard
3.5mm stereo phonejack. You can use either the supplied
earphone, or a stereo headset. The output of this jack is
monaural audio,but you will hear it in both headphones of a
stereo headset.
IMPORTANT!
Be sure to use only the supplied earphone, or stereo headset
of the proper impedance (32ft) Use of an incorrect earphone
or stereo headset may be potentially dangerous to your
hearing.
WARNING:Do not plug in the earphone or head-
phones before setting the Volume Control. You
might experience some hearing damage if the
Volume suddenly becomes too loud because of
the volume Control or Squelch Control setting.
This isparticularlytrueofthe typeofearphonethat
is placed in the ear canal.
J
11