Filter
Top Products
:!:::::=o
,..,,~~,~=.~~-~=
-====
Scanning
1.
Note: When you turn the scanner on it will always
be in SCAN Mode.
look at the lower left corner of the display. If SCNis not
displa~ed, press
@. The UBC 120XLT should begin
scanning.
2. If HOLD appears at the bottom of the display, press
@ to begin scanning.
The indicators for the selected Banks (1 through 10) appear on
the display. The indicator of the Bank currently being
monitored flashes. While the UBC 120XL T is scanning, the
word SCAN moves across the display.
Scanning stops on any active channel that is not "locked Out",
and displays the Channel Number and frequency. Scanning
resumes automatically after the transmission stops.
3. You can deselect any bank(s) from being scanned by
entering the number of the bank. The deselected bank
indicator(s) disappear from the display, and those
channels will not be scanned. This procedure helps to
speed up the scanning cycle.
Note: One Bank must always be active. You cannot
deactivate al/1 0 banks at the same time. Ifyou try
to deactivate all 10 Banks, Bank 1 will automatically
be active.
4. To restore any bank for scanning, just enter its number
again. The bank indicator will reappear on the display.
5. To stop scanning any time, press~. (HOLD appears
on the display.) The scanner remains on the displayed
channel, and only the bank indicator for that channel
appears. Press @. to resume scanning.
6. When you are stopped at a channel, you can press ~ to
step down a channel, or £ to step up a channel. Press
and hold either key to rapidly step through the
channels.
Note: You do not skip a locked out ('UO'? channel
when you use ~ or £.
16
-. --- .._--