Filter
Top Products
Installation
30 Vidikron Vision 70 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Connecting to AC Power Projector: The Vision 70 ships with
various types of AC power cords.
Choose the one that is appropriate
to your locale.
Plug the female end of the power
cord
into the AC receptacle on the
rear of the projector (AC 100V ~
240V). Then, connect the other end
to your AC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power cord is
pr
ovided for the lens motor. Plug the female end of the AC power cord into the AC input on
the rear of the lens motor assembly. Connect the other end to a 110 VAC power source.
3.7
Turning on the Power
1. Turn on your source components.
2. If this is an AutoScope-equipped projector, turn on
the main power switch at the rear of
the AutoScope lens motor. The lens motor power switch is located next to the AC input
(see above).
3. Turn on the main power switch at the rear of the projector. The POWER LED lights
orange. The LAM
P and TEMP LEDs light red briefly, then go out.
4. Press the ON
button on the remote control to turn on the Vision 70. The POWER LED
flashes orange to indicate that it is warming up.
5. When the projector is ready for use, the POWER LED lights green.
6. “Searching...” appears on the screen before the Vision 70 identifies the input signal and
r
emains there until a valid signal is detected.
7. If an incompatible input signal exceeds the range of the projector, a “No signal
supported” message appears on th
e screen. This message remains on the screen until
you change the input signal.
➤
The input voltage to the AutoScope lens motor must be between 100 and
120 VAC. Do not connect the AutoScope lens motor to a 200-240 VAC
powe
r source!
Power
switch
Caution
AutoScope Lens Motor (Rear)
AC Input
Power
Switch
to
110 VAC
Power