Filter
Top Products
Installation
Vidikron Vision 70 Series Owner’s Operating Manual 31
PRE
L
IMINAR
Y
3.8
Changing the OSD
Language
The Vision 70 OSD language is initially set to English, but can also display the menus in
French, Spanish, Italian or German. To change the OSD language:
1. Press ME
NU.
2. Select Installation from the Main Menu and press ENTER.
3. Select Language from the I
nstallation Menu and press ENTER.
4. Press or to highlight the desired language. (The change takes effect immediately.)
3.9
Adjusting the Picture
Orientation
By default, the Vision 70 is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or mounted
on a ceiling, you must change the picture orientation. To do this:
1. Press ME
NU on the remote control.
2. Select Installation from the Main Menu and press ENTER.
3. Select Picture Orientation from the Installation Menu and press EN
TER.
4. Choose Floor Rear, Ceiling Fr
ont or Ceiling Rear to match the installation method.
3.10
Primary Lens Adjustments
The Vision 70 gives you a great deal of control over the picture
size, position and focus. To access the motorized lens controls,
use the FOCUS, ZOOM and LENS SHIFT buttons on the
remote control.
FocusTo focus the projected image, press the FO
CUS button, then use the left- and right-arrow
buttons to adjust the focus.
ZoomTo make the picture smaller (zoom out), press the ZO
OM button, then use the left-arrow
( ) button.
To enlarge the picture (zoom in), press the Z
OOM button, then use the right-arrow ( )
button.
Vertical Lens ShiftTo shift the projected imag
e vertically, press the LENS SHIFT button, then use the up and/or
down-arrow ( , ) buttons.