Filter
Top Products
Installation
36 Vidikron Vision 70 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Attach Lens Mounting Assembly to Lens Motor Carriage Plate:
1. Remove the two Yaw/X Adjustment Levers and 1/4-20 Fiber Washers (item #8) fro
m the
bottom of the Anamorphic Lens Holder (item #5).
2. Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate (item #7).
Position the
bracket so that the long slot at the bottom of the lens holder is
perpendicular to the corresponding slots on the carriage plate.
3. Secure the Anamorphic Lens Holder to the plate using the Hex Bolts (item #6), Yaw/X
Adjustment Levers and Washers tha
t you removed in Step 1.
4. Use the Lens Rotation Set Screws to attach the Lens
Adapter Ring (item #1) to the Pitch
Adjustment Yoke (item #2); see Figure 3-17. (Use the curved, oval-sh
aped holes on the
Pitch Adjustment Yoke.)
5. Use the Height/Y Adjustment T-Screws (item #3), Pitch Adjustment T-Screws (item #4)
and Washers
to attach the Pitch Adjustment Yoke and Lens Adapter Ring to the
Anamorphic Lens Holder. The Yoke should be as close to the primary lens as
possible.
6. Attach the lens to the Lens Adapter Ring
by threading it clockwise.
Figure 3-17. Attaching the Anamorphic Lens to
the Lens Adapter Ring
F
O
C
U
S
LENS THREADS
INTO RING
Lens Rotation Set Screws