Filter
Top Products
Operation
Vidikron VL-26/VL-32 Owner’s Operating Manual 39
Baud Rate: Select Baud Rate from the ISF Calibration menu to set the data transfer rate of the
DView’s RS-232 SERVICE port. (This setting must match the data rate of the device connected
to the RS-232 input.)
Command Ack: The Command Ack setting enables or disables the echo of serial commands
at the source. When set to on, commands sent from the serial controller (PC or
control/automation system) are logged and/or displayed on-screen. If this is not desired, set
Command Ack to Off.
Factory Reset: To reset all DView settings to their factory defaults, select Factory Reset from
the ISF Calibration menu and press ENTER. This command is not undoable. Use it with
caution!
Splash Duration: Use Splash Duration to control how long the DView splash screen remains
on-screen after power-up; see
Figure 4-6. To prevent this screen from appearing, set the
Splash Duration to 0.
Figure 4-6. DView Splash Screen
CALIBRATED FOR: