Filter
Top Products
ViewSonic PJ1165 13
Operating The Remote Control
NOTE
• Replace the batteries whenever the remote control starts to malfunction.
• When strong lights, such as direct sunlight or light from an extremely close range (such
as from an inverter fluorescent lamp), hit the projector’s remote sensor, the remote
control may cause to function. Adjust the direction of the projector to keep light from
directly hitting the projector’s remote sensor.
The remote control works with the
projector’s remote sensors.
Front remote sensor is 3 meters with a
60 degree range (30 degrees to the left
and right of a remote sensor).
Rear remote sensor is 3 meters with a 4
degree range (2 degrees to the left and
right of a remote sensor).
Also a remote signal reflected in the screen etc. may be available. If it is difficult to send a
remote signal to the sensor directly, please try.
Since the remote control uses infrared light to send signals to the projector (Class 1 LED),
be sure to use the remote control in an area free from obstacles that could block the remote
control’s output signal to the projector.
memo
You can use the remote control as a wired remote control, by connecting the REMOTE
CONTROL port of the main unit and remote control via an audio cable (3.5 dia. Stereo mini
cable with plugs).
Using The Remote ID Feature
This is the function to properly use when you use two or three same type
projectors at the same time. This function should be used combining a
setup of a projector.
1
Set the ID number to the projector beforehand, refer ring to the item “IR
REMOTE ID” of the section “OPTION Menu”.
memo
When the ALL is selected to the item “IR REMOTE ID” of the
OPTION menu, the projector is controlled by a remote control
irrespective of the position of the ID CHAGE switch.
2
Slide the knob of the switch into the position of the ID number of the
projector you want to control.
CAUTION
• Do not disassemble the remote control.
• Do not place the remote control near the projector’s lens, fan, or vents.
• Do not drop or other wise expose the remote control to physical impact.
• Do not get the remote control wet or place objects. Doing so may result in malfunction.
• Remove the batteries from the remote control and store them in a safe place if you
won’t be using the remote control for an extended period.
approximately
3 meters
approximately
3 meters
ID CHANGE
switch