Filter
Top Products
ViewSonic PJ1165 37
Lamp
WARNING
HIGH
VOLTAGE
HIGH
TEMPERATURE
HIGH
PRESSURE
The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud
bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that
each lamp has a different lifetime, and some may burst or burn out soon after you start
using them. In addition, when the bulb bursts, it is possible for shards of glass to fly into
the lamp housing, and for gas containing mercury to escape from the projector’s vent
holes
About disposal of a lamp
• This product contains a mercury lamp; do not put in trash. Dispose of in accord with
environmental laws.
• For lamp recycling, go to www.lamprecycle.org. (in USA)
• For product disposal, contact your local government agency or www.eiae.org (in the
US) or www.epsc.ca (in Canada).
• For more information, call your dealer.
Disconnect
the plug from
the power
outlet
• If the lamp should break (it will make a loud bang when it does), unplug the
power cord from the outlet, and make sure to request a replacement lamp
from your local dealer. Note that shards of glass could damage the
projector’s internals, or cause injury during handling, so please do not try to
clean the projector or replace the lamp yourself.
• If the lamp should break (it will make a loud bang when it does), ventilate the
room well, and make sure not to breathe the gas that comes out of the
projector vents, or get it in your eyes or mouth.
• Before replacing the lamp, make sure the power switch is off and the power
cable is not plugged in, then wait at least 45 minutes for the lamp to cool
sufficiently. Handling the lamp while hot can cause burns, as well as
damaging the lamp.
• Do not open the lamp cover while the projector is suspended from above.
This is dangerous, since if the lamp’s bulb has broken, the shards will fall out
when the cover is opened. In addition, working in high places is dangerous,
so ask your local dealer to have the lamp replaced even if the bulb is not
broken.
• Do not use the projector with the lamp cover removed. At the lamp replacing,
make sure that the screws are screwed in firmly. Loose screws could result
in damage or injury.
• Use only the lamp of the specified type PRJ-RLC-011.
• If the lamp breaks soon after the first time it is used, it is possible that there
are electrical problems else where besides the lamp. If this happens, contact
your local dealer or a service representative.
• Handle with care: jolting or scratching could cause the lamp bulb to burst
during use.
• If the indicators or a message prompts you to replace the lamp (see the
section “Related Messages” and “Regarding the indicator Lamps”), replace
the lamp as soon as possible. Using the lamp for long periods of time, or
past the replacement date, could cause it to burst. Do not use old (used)
lamps; this is a cause of breakage.