Filter
Top Products
ViewSonic PJ1165 33
OPTION Menu
With the OPTION menu, the items shown in the table below can
be performed. Perform each operation in accordance with the
instructions in the table below.
(This table is continued to the following page.)
Item Description
VOLUME Adjust the volume using the S/T buttons.:
High Low
SPEAKER Select the TURN ON or the TURN OFF using the S/T buttons.:
TURN ON TURN OFF
When the TURN ON is selected, the built-in speaker works.
IR REMOTE Select a remote sensor using the S/T button (1), then
switch it using the ENTER button (2).:
(1) FRONT TOP REAR (2) (Off) (On)
memo
A sensor cannot be turned off when the other two are
off. Always at least one sensor is on.
IR REMOTE ID Select a number as an ID number for remote control using the S/T
buttons.:
ALL 1 2 3
The projector is controlled by the remote control whose ID CHANGE
switch is set into the position of the same number as this number.
When the ALL is selected, the projector is controlled by a remote
control irrespective of the position of the ID CHANGE switch.
memo
Please refer to the section “Using The Remote ID Feature”.
LAMP TIME Pressing the RESET button for about 3 seconds displays the LAMP
TIME menu.
Select the RESET using S button to reset the timer.:
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
memo
Perform this function only when you have replaced the lamp. The
lamp timer counts the used time of the current lamp, to display the
messages about the lamp. Incorrect performing causes incorrect
operation of the messages.
memo About replacing the lamp, please refer to the section“Lamp”.
FILTER TIME Pressing the RESET button for about 3 seconds displays the FILTER
TIME menu.
Select the RESET using S button to reset the timer.:
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
memo
Perform this function only when you have cleaned or replaced the
air filter. The filter timer counts the used time of the air filter after
cleaning or replacement, to display the messages about the air filter.
Incorrect performing causes incorrect operation of the messages.
memo
About caring for the air filter, please refer to the section “Air Filter”.