Filter
Top Products
ViewSonic PJ1165 35
NETWORK Menu
This projector provides the NETWORK function. If you use this
function, please set up the projector according to the Network
environment in which you use it.
memo When you use a Network suitable to the DHCP function, the
following operation is not required commonly, because the TURN
ON is selected to the item “DHCP” at the shipment time. Please see the section “Network
Setting Up”.
Item Description
SETUP Pressing the X (or the ENTER) button calls
the IP ADDRESS menu.
memo
This item performs only when the TURN
OFF is set to the item “DHCP” of this
NETWORK menu.
The IP Address is identification number of the projector on the
Network.
1. Set the IP Address using the S/T buttons.
memo The same number as the IP Address of other units cannot be
used.
Pressing the X (or the ENTER) button at the
IP ADDRESS menu calls the SUBNET
MASK menu. The SUBNET MASK is an
address of the Network.
2. Set the same number as the address of
the Network to be used.
Pressing the X (or the ENTER) button at the
SUBNET MASK menu calls the DEFAULT
GATEWAY menu. The DEFAULT GATEWAY
is the address of the main device.
3. Set the same number as the address of
the device as gateway to an outer Network.
DHCP Select the TURN ON or the TURN OFF using the S/T
buttons. :
TURN ON Ù TURN OFF
When you use a Network unsuitable to the DHCP
function, select the TURN OFF.
INFORMATION Pressing the X (or the ENTER) button
displays the INFORMATION menu.
The INFORMATION menu shows the
information about the current Network setting
as illustrated below.
RESET Select the EXECUTE using the S button to reset the NETWORK
menu items. :
EXECUTE Õ CANCEL
The items of the NETWORK menu are collectively returned to the
initial setting.