Filter
Top Products
CHECKING YOUR SCANNER 17
3. Choose About from the shortcut menu.
A dialog box confirms that the scanner is properly connected. The
About dialog box shown below is for a 6400 scanner connected to a
parallel port.
4. Click OK to close the dialog box.
That’s it. Your scanner is ready to scan. See “Scanning for the First
Time” on page 20.
CHECKING A SCANNER CONNECTED TO A USB PORT
After you have installed the scanner to a USB port, you can check if it is
properly connected using the Scanners and Cameras setting in the
Windows Control Panel.
To check the status of the scanner:
1. From the Start menu, choose Control Panel, and then Settings.
The Control Panel window opens.
Note: The scanning lamp under the scanner’s glass needs to warm up
before you can scan. A status message lets you know when the lamp is
ready. The lamp then remains ready so you don’t have to wait for it to
warm up each time you want to scan. To conserve electricity and
prolong the life of the scanner, you can set the length of time for the
lamp to remain lit before powering down. See “Setting Preferences”
on page 36.