Filter
Top Products
030-300372 Rev. A 7 July 2003
Westell Dual Connect NAT Router with DMH Technology
User Guide
5.4.2 Router Installation via USB
NOTE: The USB installation will not function for Macintosh computers. Macintosh computers must install
the Router via Ethernet connection. See section 5.4.1.
1. Connect the power supply cord to the power connector marked
~
on the rear panel of the Router. Plug the
other end of the power supply into an AC wall socket.
2. Connect the DSL phone cable from the connector marked on the rear panel of the Router to the DSL-
equipped telephone line jack on the wall. IMPORTANT: Do not
use a DSL filter on this connection. You must
use the phone cord that was provided with the Router kit.
NOTE: Your Westell modem is equipped with the latest in DSL modem technology. One of the innovative
features included within your modem is a technology called Dynamic Multi-Hybrid or DMH
TM
. This
technology enables your modem to achieve the fastest possible connection under various loop (telephone wire)
conditions. When the modem is reset, powered-up or connected to the DSL line there may be a “clicking” noise.
This “clicking” is part of the DMH technology and will stop once the modem has successfully locked to the
DSL signal.
3. Connect the USB cable from the USB connector marked
on the rear panel of the Router to the USB port
on the PC.
Congratulations! You have completed the USB hardware installation for your Dual Connect NAT Router. You must
now go to Section 6 to begin the USB driver software installation.
NOTE: Your modem’s rear panel may have additional features. See Figure 3
Figure 2. Connection via USB
12V
!