Filter
Top Products
030-300372 Rev. A 116 July 2003
Westell Dual Connect NAT Router with DMH Technology
User Guide
Protocol
Protocol
Protocol This screen informs the Router which networking protocol to use when
communicating with your ISP. This information is provided by your ISP.
Public LAN
This screen contains the settings that control how the ADSL router interacts with the local devices connected to the
router. It is not recommended that these settings be changed. The following settings are displayed.
Public LAN
Public LAN DHCP Server
Enable
Dynamic Host Configuration Protocol (DHCP) is an Internet standard that
allows the ADSL router to automatically assign IP addresses to devices
connected on the LAN network. It is advised that this is enabled for Private
LAN.
Public LAN Enable This setting enables the Public interface. This feature allows a global subnet to
exist behind your modem.
Modem IP Address This controls the IP address that the ADSL router uses for local
communication.
Subnet Mask This setting specifies the subnet mask to use to determine if an IP address
belongs to your local network.
DHCP Start Address (If
DHCP is enabled for
Public LAN)
This setting specifies the start of the IP address pool that the modem uses to
assign IP addresses to local devices.
DHCP End Address (If
DHCP is enabled for
Public LAN)
This setting specifies the end address of the IP address pool used for automatic
configuration of local devices.
DHCP Lease (If DHCP is
enabled for Public LAN)
This setting specifies the DHCP lease time.
R
Remote Access
This page allows you to configure your modem so that it can be configured remotely. Once enabled, this feature can
be manually disabled, or it will automatically disable after 20 minutes of configuration inactivity. NOTE: This
feature is not available in Bridge Mode.
Remote Access
Password The password is used to enter the modem’s web interface. It must be at least 4
characters long and contain no spaces.
URL The URL must be placed in a remote PC’s web browser in order to
communicate with your modem. If this field says “Not Connected,” you are not
currently connected to the Internet.
Enable Remote Access Remote Access is enabled after you have entered a valid password and
connected to the Internet.