Filter
Top Products
8. Test Boot Commands: When the NPS-2HD is powered
up, both switched plugs will be set in the ON position. In
order to test for proper operation, you may wish to perform
the following test. Note that it is not necessary to connect
a device to either switched outlet in order to perform
this test.
a) Reboot Plugs: To initiate a boot cycle at both plugs,
go to the NPS command prompt and type /BOOT *
and press [Enter]. Power to both plugs will be
switched OFF. After the Boot Delay Period (Default =
5 Seconds), the power to both plugs will then be
automatically switched back ON. Note that the Plug
Status Indicators on the NPS-2HD front panel will also
switch Off and On.
b) Switch Plugs OFF: To switch both plugs OFF, go to
the NPS command prompt, type /OFF * and then
press [Enter]. Power to both plugs will be switched
OFF. Note that the Plug Status Indicators will also be
switched Off.
c) Switch Plugs ON: To switch both plugs ON, go to the
NPS command prompt, type /ON * and then press
[Enter]. Power to both plugs will be switched ON.
Note that the Plug Status Indicators will also be
switched On.
9. Exit Command Mode: Type /X and press [Enter] to exit
from the NPS Command Mode, or disconnect using your
Telnet program.
This completes the introductory overview of the NPS-2HD.
Prior to installing and operating the unit, please review the
remainder of this User's Guide for important information
regarding safety considerations, as well as more detailed
installation, configuration, and operation instructions.