Filter
Top Products
4.2. Option Switches
The Option Switches select default settings for the Baud Rate,
Command Echo, Boot Delay and Disconnect Timeout. Default
settings selected via the Option Switches will be used when the
unit is reset to default parameters as described in Section 4.3.
Notes:
•
Although the Option Switches select default
settings for these features, the NPS-2HD
configuration menus can also be used to select
operating parameters as described in Section 5.
•
If Option Switch settings are changed, the new
settings will not be applied until the unit is reset
as described in Section 4.3.
Option Switch settings are described below:
Baud Rate: The default baud rate for the Console Port and
Modem Port.
Boot Delay: The default Boot Delay setting. When a boot cycle
is initiated, the Boot Delay determines the length of time that
the switched outlet will remain off until power is restored.
Command Echo: The default setting for the Command Echo for
the Console Port, Modem Port and Network Port. When
enabled, commands entered at your keyboard will be sent to
the NPS and echoed back to your display monitor.
Disconnect Timeout: The default Disconnect Timeout value.
This determines how long the NPS will wait for additional
commands before automatically disconnecting. Note that
when the NPS times out, DTR will drop, and the modem
disconnect and initialize strings will be sent.
Switch Function Up Down
* = Factory Setting