Filter
Top Products
4.3. Reset Unit to Defaults
If Option Switch settings are changed, the new settings will not
be applied until the unit is reset to default settings. There are
two ways to reset the unit to defaults:
Note: When these reset procedures are performed,
all user selected parameters, including passwords
and port names will be lost. Prior to performing
these reset procedures, it is strongly recommended
to save configuration parameters to an ASCII text
file as described in Section 7.
4.3.1. Default Button / Reset Button (Local)
Typically, this method is used when you have immediate access
to the installation site.
1. Simultaneously press the DEFAULT and RESET buttons,
located on the NPS-2HD Back Panel.
2. Release the RESET button, wait for approximately five
seconds, and then release the DEFAULT button.
4.3.2. Default Parameters Option
To reset the unit to default parameters using the General
Parameters Menu's "Default Parameters" option, proceed
as follows. Note that this method requires that you have already
connected a local or remote PC to the unit and have accessed the
command mode.
1. Access the NPS Command Mode (see Section 6.1).
2. At the NPS> command prompt, type /G and press [Enter].
The General Parameters menu will appear.
3. From the General Parameters menu, type A and press
[Enter]. If command confirmation is enabled, the unit
will display a "Sure?" prompt. Type Y and press [Enter]
to proceed with the reset procedure. After a brief pause,
parameters will be reset to default values.
Note: If the Default Parameters function is invoked
via the Network Port, the IP Address will not be
reset. If this function is invoked via the Console
Port or Modem Port, the IP Address will be reset.