Filter
Top Products
6.3. Boot/On/Off Commands
These commands are used to Boot or toggle the On/Off status of
the NPS's two switched plugs. If the same password has been
applied to both switched plugs, commands can be directed to
Plug 1, Plug 2, or both switched plugs. If a separate User
Password has been assigned to each plug, then commands can
only be applied to the plug that is owned by the User Password
entered at log in. Plugs may be specified by name or number.
Notes:
·
When User Mode is active, commands will only be
applied to plugs owned by the User's password.
·
To apply a command to both outlets, enter an
asterisk (*) in place of the plug number or name.
Commands can only be applied to both plugs when
the unit is operating in System Mode, or when both
plugs are owned by the same User Password.
·
When commands are applied to both plugs, the
NPS will delay for approximately 1 second
between actions. For example, when switching
both plugs On, the NPS will switch Plug 1 On,
delay one second, then switch Plug 2 On.
·
Wait for the "NPS>" prompt to appear before
entering commands. The prompt will not reappear
until the previous command is complete.
·
Commands are not case sensitive. All commands
are invoked by pressing [Enter].
·
If command confirmation is enabled, the NPS will
display the Status Screen after the Boot/On/Off
commands are successfully completed.
1. Boot Plug(s): To initiate a Boot cycle, type /BOOT n and
press [Enter]. Where "n" is a the number or name of the
desired plug. Note that the "/BOOT" command can also be
entered as "/BO".
Examples:
·
To boot both plugs, type /BOOT * or /BO * and then
press [Enter].
·
To boot plug 1, type /BOOT 1 or /BO 1 and then
press [Enter].