Filter
Top Products
4.1.2. Output Cable Clamp
1. Loosen Screws: Locate the two screws which secure each
output jack to the NPS-2HD back panel. Carefully loosen
each screw to provide sufficient room for the cable clamp
to be attached after it is fitted to the cable.
Note: Make certain to loosen the screws enough to
allow the cable clamp to be installed, but do not
entirely remove the screws from the NPS
back panel.
2. Connect Plug: Plug the power cable from your AC
powered device into the output jack. Make certain that the
plug is firmly seated. Note that the total load for each
outlet must not exceed 20 amps.
3. Fit Clamp to Plug: Carefully slip the output cable clamp
(See Figure 4.1) over the output plug, making certain that
the two slots at the base of the clamp are properly seated
over the screws which secure the output jack to the back
panel. The U-shaped cutout, located at the back of the
clamp, should face downwards in order to allow the clamp
to fit over the cable.
4. Tighten Screws: Tighten the screws which secure the
output cable clamp to the output jack.