Filter
Top Products
DocuTech 128/155/180 HighLight Color Operator Guide 4-25
Problem Solving
Binder tape fault
NOTE: Production publisher configuration only
To clear a binder tape fault:
1. Open the finisher doors.
2. Open the top cover.
WARNING: The binder tape adhesive is hot, approximately 425°F
(218°C). Allow the binder to cool for 5 minutes with the finisher
doors and top cover open before touching the binder tape.
3. Follow the instructions on the screen to determine the area (17
or 18) that should be cleared.
4. If area 17 is displayed and the binder tape is present, stop and
follow the WARNING. Remove the binder tape and paper.
Proceed to step 6.
5. If area 17 is displayed and the binder tape is not present,
follow the instructions on the area 17 label and remove all
paper.
6. Ensure that area 17 is clear of all binder tape adhesive. If the
area is not clear, clean the binder using the procedure,
"Cleaning the binder," in this guide.
WARNING: The binder tape adhesive is hot, approximately 425°F
(218°C). Allow the binder to cool for 5 minutes with the finisher
doors and top cover open before touching the binder tape.
7. If area 18 is not displayed, proceed to step 10.
8. If area 18 is displayed and the entire binder tape length is not
aligned with the tape feeder assembly, stop and follow the
WARNING. Proceed to step 10.
9. If area 18 is displayed and the entire binder tape length is
aligned with the tape feeder assembly, proceed to step 10.
10. Remove the binder tape.
Sheets are spilling
out of the top tray
The capacity of the top tray is 500 sheets of substance 20 (75 g/m2)
or 2 inches (51 mm) in height. When intermixed stock or paper
heavier than substance 20 (75 g/m2) is being run, the capacity of
the top tray is reduced.
500 sheets of substance 20 (75 g/m2) is equal to approximately:
415 sheets of substance 24 (90 g/m2)
310 sheets of substance 32 (120 g/m2)
225 sheets of substance 110 (200 g/m2)
If using any paper heavier than substance 20 (75 g/m2) or
intermixed stock of different weights, unload the top tray before the
count in the tray reaches its capacity limit.
Refer to the satisfaction guides in the "Technical information"
chapter.
Table 4-3. Resolving a finisher problem