Filter
Top Products
DocuTech 128/155/180 HighLight Color Operator Guide 2-11
System components
Inverter feeder/stacker
NOTE: High volume printer configuration only
Each output feeder/stacker has offsetting capability and a capacity
of 2500 sheets of 20 pound or 80 gsm paper.
This capacity does not apply to 11 by 17 inch and A3 papers.
Because of the additional weight these large sheets add to the
bins, each bin is restricted to hold only up to 1500 sheets of A3 or
11 by 17 inch papers, for safety reasons.
Figure 2-4. High capacity stackers (HCS)
The stackers can stack the printed output in the bin three ways:
1. Directly onto the bin platform.
2. Into a container that is set on top of the bin platform.
NOTE: The stacking capacity is approximately 100 to 150 sheets
less when stacking into a container.
3. Onto a pallet without a container (for paper sizes 11 by 17
inches or A3 only).
Using the stacking windows on the user interface, you can select
the level to which paper will be stacked in the HCS.
A stacking elevator maintains the paper at the proper level for
stacking and lowers the stack for unloading. An offset mechanism
offsets printed sets toward the front or back of the HCS bin.
The elevator platform lowers under the following conditions:
• The bin capacity has been reached.
• A selection to lower the platform is entered at the printer
control console or a user interface window.
• The job being printed reaches a designated unload boundary.
Each HCS bin has unlinked double doors to give you easy and
safe access for unloading output from the printer.
The elevator bin platform automatically rises when the doors are
closed after the stacker has been unloaded.
Bin control panels
on stackers
Each stacker bin has a control panel consisting of buttons and
indicators.