Xerox 180 Printer User Manual


 
DocuTech 128/155/180 HighLight Color Operator Guide 4-27
Problem Solving
Figure 4-24 Removing the stitcher wire plug
5. Remove the stitcher wire plug.
The stitcher wire plug is located above the binder area, as
shown in figure 4-24.
Press and hold down the release clip.
Pull the plug out of the stitcher head.
6. Remove any damaged wire.
Using the wire cutters, slowly and carefully pull
approximately 3 feet (1 meter) of wire out of the stitcher
plug.
The wire cutter tool needed to perform this procedure is
located next to stitcher spool B, as shown in the lower left
corner of figure 4-23.
Cut the wire carefully, leaving approximately 2 inches (50
mm) of wire extending from the stitcher plug, as shown in
figure 4-25.