Filter
Top Products
2-24 DocuTech 128/155/180 HighLight Color Operator Guide
System components
Accessing DocuSP remotely (Remote Workflow)
Remote Workflow, a remote graphical user interface (GUI), is
available for installation from a CD. Remote Workflow allows you
to manage your DocuSP-based printers from a single PC or Sun
workstation. You may set your preferences from the remote client
to disable or enable some or all connections.
Remote Workflow allows you to configure the printers that you
want to manage, and provides real time status of the printers. You
may switch between the printers that you are managing, but you
can display only one printer GUI at a time.
The remote client GUI looks and functions the same as the local
DocuSP GUI on the controller.
Moving the controller
To ensure consistent performance and avoid any damage to
equipment, follow these rules for placing the components of the
workstation controller.
Do:
Use the controller stand that comes with your printing system
equipment.
Keep the processor in an upright, vertical position.
Allow at least 6 inches / 152 mm of unobstructed space at the front
and rear of the processor, so the fan and vents are not blocked.
CAUTION: Do not place the monitor on top of the processor. Do
not block any fan or vent on the front, sides, or rear of the
processor.
Do not:
Do not place the monitor and processor on a desk or table top.
Do not place the monitor on top of the processor.
Do not allow any piece of equipment to blow warm air into the air
intake vents of the processor.
Do not place the processor on its side, or in any other position but
the upright, vertical position achieved by using the controller
stand.
Do not place the processor or monitor on top of the printer.
Tape drives overview
The DocuTech 128/155/180 HLC supports several types of tape
drives that may be used to load resources (forms, fonts, etc.) or to
submit offline LCDS print jobs.
A 26-track cartridge tape drive can be used only to import
resources to the system disk. A 9-track or 36-track tape drive can
be used to submit print jobs to the printer or to load resources.