Filter
Top Products
PREINSTALLATION
LPS space requirements
Dimensions and weights of the 4890 HighLight Color LPS
controller, components, and the printer, are listed in this section,
along with diagrams to help you visualize the sizes and total
space requirements. Diagrams depicting examples of allowable
shared space arrangements for multiple printer installations are
also provided.
There must be a 78 inch/1981 mm vertical clearance (from the
floor to the lowest part of the ceiling or to any obstruction that
hangs below the ceiling) throughout the entire area. In addition,
your LPS must be installed in a fixed location with a minimum
clearance space of 36 inches/914 mm around all sides of each
piece of equipment for access by service personnel.
Components may share the 36 inch/914 mm general service
clearance areas, but they may not share the 24 inch/610 cm
operator area in front of each component.
Space planning templates and a grid are provided at the end of
this chapter to assist you in planning the placement of your LPS.
The following diagrams represent top views of the components,
surrounded by the required 36 inch/914 mm clearance on all
sides.
XEROX 4890 HIGHLIGHT COLOR LPS INSTALLATION PLANNING REFERENCE 1-5