Filter
Top Products
PREINSTALLATION
Dry ink
Dry ink is the powder that forms the image on the printed page.
Dry ink is combined with carrier beads and stored in a bottle
mounted on the black developer housing (for black dry ink) and
on the customer changeable unit (CCU) for color dry ink.
There are five dry ink colors available in addition to black: red,
green, blue, magenta and cyan. The dry ink bottles come six to
a carton for black dry ink and three to a carton for color dry ink.
You should have at least one extra container of black dry ink,
and one of each color that you normally use.
Use only Xerox dry ink in your LPS. For ordering information
refer to the consumable supplies table in the “Postinstallation“
chapter.
Fuser lubricant
Fuser lubricant is a consumable item required by the LPS. At
least one box needs to be ordered and kept on hand for
installation by the Xerox service representative. The printer holds
up to three tubes when full and is refilled to capacity during each
service call. Refer to the consumable supplies table in the
“Postinstallation” chapter.
Developer
Developer is not a consumable material, but may become
contaminated and will then need to be replaced. Your site
representative will replace the developer, if necessary.
Developer is not ordered by the customer, even if it must be
replaced.
Diskettes
Diskettes are optional items that provide loading and backup of
fonts, forms, and user files to and from the LPS system disk. The
recommended media for use in the floppy disk drive is the
standard 96 tracks per inch (tpi), high-density, double-sided
diskettes. The floppy disk drive is 1.2 MB high density. Either
high-density/high-capacity, and 1.2 MB or double density and low
capacity 360 KB floppy disks may be used. Refer to the
consumable supplies table in the “Postinstallation” chapter.
Stitcher wire
Stitcher wire is a consumable item for an LPS with the high-
capacity stitcher/stacker option. You need to order stitcher wire
reels and keep them on hand. They are installed by your service
representative, or operators who have completed OCM or ACT
training. Refer to the consumable supplies table in the
“Postinstallation” chapter.
1-30 XEROX 4890 HIGHLIGHT COLOR LPS INSTALLATION PLANNING REFERENCE