Filter
Top Products
Xerox 490/980 Color Continuous Feed Printing System Color Calibration Process for v1.1.6 Software
Color Management Guide 5-29
Note
As a reminder, the queue name used to submit the job in the next step is
[CalibrationConfirmation].
3. Reference
Appendix B and submit the appropriate test pattern to the printer using Line
Printer Remote (LPR). Return to this procedure when you are finished.
4. The command prompt window should look similar to the following when you are finished
typing:
5. After you have confirmed that you have the appropriate text in the command prompt
window, press <Enter> to submit the job to the printer.
6. Close the command prompt and Windows Explorer windows.
7. Save the last three print-outs of the test pattern.
Note
In the following step, the white paper is used as a backdrop under the test pattern print to
prevent the viewing surface from interfering with the color squares.
8. Place a piece of white paper on a table, then place the test pattern on top of the white
piece of paper.
9. Place the SIR on top of the test pattern. Ensure that the square cut outs are in line with the
100% color squares of the test pattern.
10. Using the provided Xerox 490/980 Color Continuous Feed Printing System SIR, evaluate by
eye if the 100% square of colors on the test pattern are lighter or darker in density than the
Light shade or the Dark shade of the SIR. Repeat this procedure for each of the four colors
(Y/M/C/K). Write down the results of each observation for recording purposes.
11. If the color densities of each color square are within the specified parameters of the Xerox
490/980 Color Continuous Feed Printing System SIR, color calibration has been successfully
completed. If the color densities of each square are not within the specified parameters of
the Xerox 490/980 Color Continuous Feed Printing System SIR, color calibration must be
repeated. Please go back to the
Color Density Adjustment on page 18 of Chapter 4 and
repeat all procedures up to this point again.
100% SIR