Filter
Top Products
DocuColor 5000AP Administrator Guide
3-17
3. Profiles
NOTE: Refer to page 3-20 for information on the 2nd Bias
Transfer Belt.
12. If required, choose an Aligner Roll Pressure setting.
TIP: The default setting is 0. It is recommended that you leave
this option at its default setting until you run test prints and
evaluate the output of the prints. Test Print is discussed in more
detail in Step 16.
NOTE: Refer to page 3-24 for information on the Aligner Roll
Pressure.
13. If required, choose a Paper Tray Air Assist option from the
pull-down menu.