Filter
Top Products
235
6.4 Printing Using the ftp Command (6030/6050 only)
Message List
This section explains messages that may be displayed during printing using the
ftp command.
Status: Cannot establish connection for data transfer.
Action: Wait a few moments and try again.
Status: Cannot create a control file using the STOR command.
Action: Wait a few moments and try again.
Status: Cannot create a job file using the LJ command.
Action: Wait a few moments and try again.
Status: Cannot create a socket in passive mode.
Action: Wait a few moments and try again.
Status: Cannot open a parameter file for creating the specified file.
Action: Wait a few moments and try again.
Status: Command (XX) received not supported.
Action: Enter the correct command.
Status: A control connection error occurred in the FTP command wait status.
Therefore, the connection was disconnected.
Action: For another transfer, establish the connection again.
Can't build data connection
Can't create control file, please try later
Can't create status file, please try later
Can't open passive connection
Cannot create file "xx" or permission problem
Command "xx" not understood
Control connection read error