Filter
Top Products
IP Address
Phaser® 8200 Color Printer 2
■ PostScript Utility files can be used on hosts that do not have BOOTP or DHCP— see the ReadMe
file on your printer’s CD-ROM. The PC ReadMe file is in the UTILS directory; the Macintosh
ReadMe file is in the Network Utilities folder.
Note
When two or more IP address methods are used simultaneously, the printer uses the first
address that it successfully obtains.
Setting the IP address from the front panel
For information about using the front panel, refer to the Front Panel section of the Phaser 8200 Color
Printer User Guide on the Software and Documentation CD-ROM.
Note
DHCP must be set to OFF before you can set the IP address from the printer’s front panel.
1. With Menus highlighted, press the OK key.
2. Press the Scroll Down key to scroll to the Network Setup Menu.
3. Press the OK key.
4. Scroll to TCP/IP Address.
5. Press the OK key.
6. Press the Scroll Down or Scroll Up key to scroll to the correct number for the first digit of the
address, then press the OK key to accept that digit.
7. Repeat step 6 for each remaining digit.
8. Scroll to TCP/IP Network Mask and press the OK button.
9. Press the Scroll Down or Scroll Up key to scroll to the correct number for the first digit of the
address, then press the OK key to accept that digit.
10. Repeat step 9 for each remaining digit.
11. Scroll to TCP/IP Gateway and press the OK button.
12. Press the Scroll Down or Scroll Up key to scroll to the correct number for the first digit of the
address, then press the OK key to accept that digit.
13. Repeat step 12 for each remaining digit.
14. To exit the menu system, scroll to Exit and press the OK key.
Information Required for IP Addressing
Information Comments
Internet (IP) address for the printer Format is xxx.xxx.xxx.xxx, where xxx represents a decimal number
from 0 - 255.
Network Mask If you are unsure, leave this blank; the printer chooses an
appropriate mask.
Default Router/Gateway address If you want to communicate with the printer from anywhere other
than the local network segment, you need the router address.