Filter
Top Products
4-58 Keypad controls and menus
Applicator
You will use the Applicator option to enable or disable applicator mode. This
option applies only to users integrating the printer with an applicator
system.
To enable or disable the applicator:
1 If the printer is in a Ready state, press the PRINT/PAUSE key to pause
the printer.
2 Press the NEXT or PREVIOUS key until the Options menu is displayed.
Then press the SELECT key.
3 Press the NEXT or PREVIOUS key until the Applicator menu is
displayed.
4 Press the + or – key until the desired setting is displayed. Available
options are Enabled or Disabled.
5 Press the SELECT key to confirm your choice.
Note: Before printing labels in applicator mode, use the Synchronize Labels
command from the Operation menu to synchronize the printer with the
applicator system.
The following message will appear if you attempt to print without
synchronizing.
Synch Required
Applicator
Enabled
Pause: Options
Press SELECT