Filter
Top Products
4-22 Keypad controls and menus
Test Print
The QLS-8100 Xe is equipped with a number of built-in test patterns used for
checking color alignment, print quality, and printhead integrity.
To perform a test print:
1 If the printer is in a Ready state, press the PRINT/PAUSE key to pause
the printer.
2 Press the NEXT or PREVIOUS key until the Cal & Setup menu is
displayed. Then press the SELECT key.
3 Press the NEXT or PREVIOUS key until the Test Print menu is displayed.
4 Press the + or – key until the test pattern is displayed. The following test
patterns are available.
Test Pattern 2”, 4”, 6”, 7”, 8” – Prints a crosshatch pattern to check print
quality.
Block Pattern (All) – Prints a spot color block pattern used for color
alignment.
Proc. Block (CMYK) – Prints a process block pattern used for color
alignment.
Proc. Block (KCMY) – Prints a process block pattern used for color
alignment.
Horiz. Line Pattern – Used to check printhead angularity.
Large Blocks 2”, 4”, 6”, 7”, 8” – Prints a solid block of each color.
5 Press the SELECT key to confirm your choice.
Test Print
Test Pattern = 2 in.
Pause: Cal & Setup
Press SELECT