Interfaces
ZebraNet® PrintServer II for Ethernet Networks
980531-001 A LP 2824-Z User Guide 57
ZebraNet® PrintServer II for Ethernet Networks
This interface uses an RJ-45 straight-through cable type. The table below provides the pinout
assignments.
The figure above has the perspective looking into the printer RJ-45 modular connector.
You can refer to the ZebraNet® PrintServer IITM for Ethernet Networks Installation and
Operation Guide for details regarding this interface.
The RJ-11 jack on Ethernet boards is used for factory tests only.
Signal Pin Pin Signal
Tx+ 11Tx+
Tx- 22Tx-
Rx+ 33Rx+
--- 44---
--- 55---
Rx- 66Rx-
--- 77---
--- 88---