Filter
Top Products
9. Refer to Figure 7. Thread the media through the media guides.
NOTE: If the media guides must be changed to accommodate the
width of the media, turn the green media guide adjuster (refer to
Figure 7). The media guides should just touch, but not restrict, the
edges of the roll.
10.Continue to thread the media past the peel bar (refer to Figure 7).
11.Place the media hanger into the two mounting slots (refer to Figure 8).
12.Close the printhead by pressing down at both arrows (refer to Figure 9).
13.Close the top cover and turn on the printer or press the feed button if
the printer is already on (see “Auto Calibration” on page 25 for more
information).
8
Media
Guide
Adjuster
Media
Guides
Peel Bar
Figure 7