Zebra Technologies UMAN-QLP-001 Printer User Manual


  Open as PDF
of 86
 
22
QL Plus Series User Guide
nal supply through the rear feed slot, between the media
guides and up through the media compartment as shown.
Make sure the side of the media you will be printing on
faces the print head.
3. Close the Media Cover: Refer to Figure 9.
• Ifyouplantousetheprinterinthetear-off mode, close
the media cover as shown at “2”, then rotate the latch as-
sembly as shown until it locks into place, as shown at “4”.
• Ifyouplantousetheprinterinthepeel-off mode, peel
a few labels off of the media and pull it out of the printer
as shown at “1”. Close the media cover as shown at “2”.
Rotate the “EZ-Peel” peeler bar until it locks into place on
the latch, as shown at “3”, then rotate the Latch as shown
until it locks into place, as shown at “4”.
• TurnontheprinterorpresstheFeedbuttoniftheprinter
is already on.
The printer will advance the media to the next label, if
printing labels. If you are printing on journal media, the
printer will advance a short strip of media.
Media Cover
“EZ-Peel” Peeler
Bar
Flip down if using media in
the peel-off mode.
Latch
Assembly
Pull Media out of
Printer
Figure 9: Closing the Media Cover
 previous next