Zebra Technologies UMAN-QLP-001 Printer User Manual


  Open as PDF
of 86
 
31
QL Plus Series User Guide
If you have a printer equipped with the Kickstand option,
you must first remove the belt clip retainer as shown in Figure
15, retaining the two screws holding the retainer to the lower
cover. Arrange the communications cable in a broad loop as
detailed above, and capture it in the strain relief feature on the
bottom of the belt clip retainer. Then re-secure the belt clip
retainer to the bottom cover of the printer.
RefertotheUsingtheAccessoriessectionformoreinformationonthe
useofthekickstandoption
Figure 15: Communications Strain Relief with Kickstand option
1. Remove Belt Clip Retainer,
along with Belt Clip and
Kickstand.
2. Press communications
cable into strain relief feature
on bottom of Belt Clip
3. Reassemble Belt Clip to
bottom cover.
Thekickstandisnotshowninthisviewforclarity
 previous next