Zebra Technologies UMAN-QLP-001 Printer User Manual


  Open as PDF
of 86
 
42
QL Plus Series User Guide
WLAN Module Using 802.11g Radio
The following section only applies when the 802.11g WLAN module (With FCC ID: I28MD-ZLAN11G) is
installed in a QL Plus series printer (note that only one of the radio options can be installed in the printer at
one time). Other than conditions specified elsewhere in this manual, only one of the radio options can be
installed in the printer at one time and the antenna used for these transmitters must not be co-located or
must not operate in conjunction with any other antenna.
QL Plus models have the FCC ID number on a label on the back of the unit.
Caution•UseofaQLPlusseriesprinterwiththeradiomodule
markedwithFCCID:I28MD-ZLAN11GmeetstheFCCrequirementsfor
radiofrequency(RF)radiationexposureinthestandardbodyworn
congurationwithnominimumseparation.Inthisconguration,
whichapplieswhetherthebeltcliporshoulderstrapisused,theface
oftheprinterfromwhichpaperistransportedisfacingawayfromthe
user’sbody.Thestandardcongurationmustalwaysbeusedwhen
theprinterisbodyworn.
The QL 220 Plus, QL 320 Plus, and QL 420 Plus printers with
this radio option have been SAR tested. The maximum SAR
value measured for each model is listed below:
Model
SAR value W/Kg (1g average)
)
QL220 Plus 0.005
QL 320 Plus 0.002
QL 420 Plus 0.004
European Regulatory Information for this Radio
AT BE CY CZ DK
EE FI FR DE GR
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE GB
Note: -Member states in the EU with restrictive use for this device are crossed
out!
This device is also authorized for use in all EFTA member states (CH, IS, LI, NO)
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.
 previous next