Zebra Technologies UMAN-QLP-001 Printer User Manual


 
37
QL Plus Series User Guide
WLAN Module Using 802.11b CF Radio (North America)
The following section only applies when the CF (Compact Flash) WLAN module
(With FCC ID: I28MD-RW4137) is installed in a QL Plus series printer (note that only one of the radio op-
tions can be installed in the printer at one time). Other than conditions specified elsewhere in this manual,
only one of the radio options can be installed in the printer at one time and the antenna used for these
transmitters must not be co-located or must not operate in conjunction with any other antenna.
QL model printers have the FCC ID number label on the front of the module, and QL Plus models have the
FCC ID number on a label on the back of the unit.
Caution•UseofaQLPlusseriesprinterwiththeradiomodule
markedwithFCCID:I28MD-RW4137meetstheFCCrequirementsfor
radiofrequency(RF)radiationexposureinthestandardbodyworn
congurationwithnominimumseparation.Inthisconguration,
whichapplieswhetherthebeltcliporshoulderstrapisused,theface
oftheprinterfromwhichpaperistransportedisfacingawayfromthe
user’sbody.Thestandardcongurationmustalwaysbeusedwhen
theprinterisbodyworn.
The QL 220 Plus, QL 320 Plus and QL 420 Plus printers with
this radio option have been SAR tested. The maximum SAR
value measured for each model is listed below:
Model
SAR value W/Kg (1g average)
)
QL220 Plus 0.0618
QL 320 Plus 0.0500
QL 420 Plus 0.0432