Filter
Top Products
Parameter Description Default
Interdigit (10 ms)
Specifies the amount of time the VoIP
Subsystem waits after the dial string has
matched a dial pattern. After this amount
of time, the VoIP Subsystem will go
ahead and dial that number.
(The range is 0 to 65535 in units of 10
ms)
500
(5 s)
Dialing (10 ms)
Specifies the amount of time between
digits before a timeout occurs. This may
be overridden by the ‘p’ parameter in a
Dial String.
(The range is 0 to 65535 in units of 10
ms)
1000
(10 s)
Hangup Disconnect (10 ms)
Specifies the amount of time to wait (after
the disconnect command) before
transitioning to the standby state.
(The range is 0 to 65535 in units of 10
ms)
85
(850 ms)
Hangup Silence (10 ms)
Used if Hangup Disconnect is not enabled;
that is, does not have a value.
(The range is 0 to 65535 in units of 10
ms)
1000
(10 s)
No Answer (s)
Relative to call forwarding -- time after
which a call-waiting call is considered to
be a No Answer call. After this time the
call will be forwarded if Forward on No
Answer is enabled. (The range is 0 to
65535 s)
20 s
Pause Wait (10 ms)
Time that device will pause when a pause
symbol is entered in a string that will be
dialed onto the PSTN via the FXO port.
(The range is 0 to 65535 in units of 10
ms)
300
(3 s)
Timeout Tone (10 ms)
If a timeout occurs during dialing or
answering, a busy signal is sent to the
telephone. The dialing duration specifies
the amount of time to send the busy
signal. (The range is 0 to 65535 in units of
10 ms)
1000
(10 s)
Timeout Pause (10 ms)
Specifies the amount of time between the
busy and alert tones. (The range is 0 to
65535 in units of 10 ms)
100
(1 s)
Chapter 9: User Configuration 47