Filter
Top Products
Bridging Configuration 91
need to configure a Remote Node in order to dial out to another
office.
Remote Node Setup
Follow the procedure in Chapter 5 to fill the protocol-independent
parameters in Menu 11, Remote Node Profile. For the protocol-
dependent parameters, follow the ensuing instructions:
1. Bridge - Make sure this field is set to Yes.
2. Edit IP/IPX/Bridge - Press the space bar to change it to Yes
and press Enter to go to the network layer options menu as
seen below:
Figure 9-2 Remote Node Bridging Configuration
3. Dial-On-Broadcast - This field is necessary for the Prestige on
the caller side LAN. When set to Yes, any broadcasts coming
from the LAN will trigger the Prestige to make a call to that
Remote Node. If it is set to No, the Prestige will not make the
outgoing call.
4. Ethernet Addr Timeout (min) - In this field, enter the time
(number of minutes) that you wish the Prestige to retain the
Ethernet Addr information in its internal tables while the line is
down. If this information is retained, then the Prestige will not