Filter
Top Products
Chapter 9 - Fax Operation
9-7
Command Value Description
n=1 Received page good.
n=2 Page bad; retrain requested.
n=3 Page good; retrain requested.
n=4 Page bad; procedure interrupt requested.
n=5 Page good; procedure interrupt requested.
+FREL=n Phase C received EOL alignment:
n=0 The EOL patterns are bit aligned as received.
n=1 The last received bits of EOL patterns are
byte aligned by the DCE, with necessary zero
fill bits inserted. Refer to TIA PN-2388 for
details.
+FREV? Request the DCE revision identification.
+FSPL=n "Enable polling" command:
n=0 Disable polling.
n=1 Enable polling.
All other +F commands are not supported, but the modem will respond OK. In
many cases this means "don't care." See PN 2388 for command details.
Class 2 Command Responses
Response Value Function and Description
+FCFR Confirmation .
+FCIG:"string" Report remote ID response CIG.
+FCON Facsimile connection response.
+FCSI:"string" Report remote ID response CSI.
+FDCS:vr,br,wd,ln,
df,ec,bf,st
Report session parameters response; refer to
+FDCC=.... command.
+FDIS:vr,br,wd,ln,
df,ec,bf,st
Report session negotiation parameters
response; refer to +FDCC=.... command.
+FDTC:vr,br,wd,ln,
df,ec,bf,st
Report remote capabilities response; refer to
+FDCC=.... command.
+FET:n Post page message response; refer to the
+FET=n command.
+FHNG:n Call termination status response.
n=00 Normal and proper end of connection.
n=10 Transmit error on phase A hang up code.
n=20 Transmit error on phase B hang up code.
n=40 Transmit error on phase C hang up code.
n=50 Transmit error on phase D hang up code.
n=70 Receive error on phase B hang up code.
n=90 Receive error on phase C hang up code.
n=100 Receive error on phase D hang up code.
+FNSC:"HEX string" Report the non-standard facilities command frame.