Filter
Top Products
Chapter 9 - Fax Operation
9-10
Command Value Description
+FMI? Request DCE manufacturer identification.
+FMM? Request DCE model identification.
+FMR? Request DCE revision identification.
+FMS=n Minimum phase C speed parameter. refer to
+FMINSP Class 2 command in previos section
for parameter settings.
+FNR=rpr, tpr,
idr, nsr
Negotiation message reporting control
parameters:
rpr=0 Receiver parameters are not reported. +FIS:
and +FTC: response reports are suppressed.
rpr=1 Receiver parameters are reported. +FIS: and
+FTC: response reports are generated.
tpr=0 Transmitter Parameters are not reported. +FCS:
response reports are suppressed. (+FCS
parameter is still loaded)
tpr=1 Transmitter Parameters are reported. +FCS:
response reports are generated.
idr=0 ID Strings are not reported. +FTI: +FCI: and
+FPI: response reports are suppressed.
idr=1 ID Strings are reported. +FNF:, +FNS: and
+FNC: response reports are generated.
nsr=0 Non-standard frames are not reported. +FTI:
+FCI: and +FPI: response reports are
suppressed.
nsr=1 Non-standard frames are reported. +FTI:,
+FCI: and +FPI: response reports are
generated.
+FNS="string" Non-standard byte string parameter.
"string": string of hexadecimal coded octets.
+FPI="string" Local fax station ID string, for polling Rx.
+FPP=n Packet protocol control parameter:
n=0 Disable the DCE-DTE packet protocol.
n=1 Enable the DCE-DTE packet protocol. All
multi-character messages from the DCE are
sent to the DTE using a simple packet protocol
data link.
+FPR=n Serial port rate control parameter:
n=0 Automatic DTE rate detection by the DCE.
n>0 Serial rate is fixed at the value multiplied by
2400 bps. For example, when n=8, the DTE
rate is equal to 19200 bps (8x2400).
+FPS=n Page transfer status: refer to the +FPTS Class 2
command in previous sections for settings.