Filter
Top Products
Prestige 652 ADSL Security Router
Filter Configuration 16-17
Figure 16-16 Sample Filter Rules Summary — Menu 21.1.9
After you have created the filter set, you must apply it.
Step 1. Type 11 in the main menu to go to menu 11 and type the remote node number to edit.
Step 2. Go to the Edit Filter Sets field, press [SPACE BAR] to choose Yes and press [ENTER].
Step 3. This brings you to menu 11.5. Apply the example filter set (for example, filter set 3) in this
menu as shown in the next section.
16.6 Applying Filters and Factory Defaults
This section shows you where to apply the filter(s) after you design it (them). Sets of factory default filter
rules have been configured in menu 21 (but have not been applied) to filter traffic.
Menu 21.1.9 - Filter Rules Summary
# A Type Filter Rules M m n
- - ---- --------------------------------------------------------------- - - -
1 Y IP Pr=6, SA=0.0.0.0, DA=0.0.0.0, DP=23 N D F
2 N
3 N
4 N
5 N
6 N
Enter Filter Rule Number (1-6) to Configure: 1
M = N means an action can be taken
immediately. The action is to drop the
packet (m = D) if the action is matched and
to forward the packet immediately (n = F) if
the action is not matched no matter whether
there are more rules to be checked (there
aren’t in this example).
This shows you that you have
configured and activated (A =
Y) a TCP/IP filter rule (Type =
IP, Pr = 6) for destination
telnet ports (DP = 23).