Filter
Top Products
IES-5000/5005/6000 Support Notes
68
For this example, assign VLAN 200(PVID) to ENET1 and ENET2. Also, assign
VLAN 10 and VLAN 20 to Port1 and port2 respectively.
CI command:
TGE1> switch port pvid up1 200
TGE1> switch port pvid up2 200
TGE1> port pvc set 7-1-0/33 DEFVAL llc 10 0
TGE1> port pvc set 7-2-0/33 DEFVAL llc 20 0
1.3 Port Isolation
On the IES-5000, you can isolate ports without configuring VLAN groups in the CLI.
CI command:
TGE1> switch isolation enable
2. Prestige 660R-61(P791) Settings
Please refer to the steps in the previous application.
802.1x Application
IEEE 802.1x port-based authentication can be used to prevent unauthorized ports
(clients) from gaining access to the network. It is an extended authentication protocol
that allows support of RADIUS (Remote Authentication Dial in User Service,
RFC2138, 2139) for centralized user profile management on a network RADIUS
server.
The following figure shows a network example where the IES-5000 acts as an
authenticator to provide 802.1x authentication. In this example, the supplicants (PC1
and PC2) want to gain access to the application server.
All contents copyright (c) 2008 ZyXEL Communications Corporation.