Filter
Top Products
IES-5000/5005/6000 Support Notes
6
Configure the P-870H-51:
In this scenario, we will use the CPE P-870H-51 with factory-default setting.
How to set the P-870H-51 to factory-default?
Press the RESET button on the back-end plane of the housing (you can see it in the following
picture). Keep it pressed down for several seconds, until you see that the POWER LED is
blinking, which means the factory default setting is being applied to the device.
All contents copyright (c) 2008 ZyXEL Communications Corporation.