Filter
Top Products
P-334U/P-335U User’s Guide
Appendix F Log Descriptions 307
Log Commands
Go to the command interpreter interface.
Configuring What You Want the ZyXEL Device to Log
1 Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the ZyXEL Device is to record.
2 Use sys logs category to view a list of the log categories.
Figure 194 Displaying Log Categories Example
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras>?
Valid commands are:
sys exit ether aux
ip ipsec bridge bm
certificates cnm 8021x radius
ras>
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
Figure 195 Displaying Log Parameters Example
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/
1:show debug type]
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
SIG Signature
NONCE Nonce
NOTFY Notification
DEL Delete
VID Vendor ID
Table 133 RFC-2408 ISAKMP Payload Types (continued)
LOG DISPLAY PAYLOAD TYPE