Filter
Top Products
Prestige 100L IDSL Router
4-4 Remote Node Setup
LAN-to-LAN Application
A typical LAN-to-LAN application is to use your Prestige to call from a branch office to the headquarters,
as depicted in the following diagram.
Figure 4-3 LAN-to-LAN Application
For the branch office, you need to configure a Remote Node in order to dial out to headquarters.
Additionally, you may also need to configure Static Routes if some services reside beyond the immediate
remote LAN.
Remote Node Setup
Follow the procedure in the preceding Chapter to fill the protocol-independent parameters in Menu 11,
Remote Node Profile. For the protocol-dependent parameters, follow the instructions below.
Table 4-3 Protocol-dependent Parameters for Remote Node Setup
FIELD DESCRIPTION
EXAMPLES
IP Address Enter the IP address of the gateway at the remote site (in
this case, headquarters). If the remote router is using a
different IP address than the one entered here, your
Prestige drops the call.
Edit IP Press [space bar] to change it to Yes and press the
[Enter] key to go to Menu 11.3 – Remote Node Network
Layer Options menu as shown in the following figure.
No/Yes