Filter
Top Products
Fax Operation 57
Command Syntax Description
+<command>=<value> Execute a command or set a parameter.
+<command>=? Read permissible settings.
+<command>? Read current setting.
Supported Commands (per TIA PN2388 8/20/90)
Command Value Description
+FAA=n Auto-answer mode parameter:
n=0 Answer as set by +FCLASS.
n=1 DCE answers and auto-determines
type.
+FBADLIN=
<value>
0-255 Bad line threshold (number of
consecutive bad lines for a bad page
parameter):
Determine if Copy Quality OK on the
T.30 flow chart . <value>=0 to 255; a
value of 0 implies that error checking
is disabled.
+FBOR=n Phase C data bit order:
n=0 Select direct bit order.
n=1 Select reversed bit order in receiving
mode for phase C data.
+FBUF? Buffer size; read only parameter:
Allow DTE to determine the
characteristics of the DCE’s buffer
size.
+FCIG="string" Local fax station ID string, for polling
Rx.
+FCLASS=n Service class selection: Refer to
+FCLASS Class 1 command in
previous section.
+FCON DCE responds fax connection .
+FCQ=n Copy quality check capability