Enterasys Networks D2G124-12P Manual

A SERVICE OF

next previous

Using the Command Line Interface

D-Series CLI Reference 1-5

Using the Command Line Interface

Starting a CLI Session

Connecting Using the Console Port

ConnectaterminaltothelocalconsoleportasdescribedinyourD‐SeriesInstallationGuide.The

startupscreen,Figure 1‐1,willdisplayontheterminal.YoucannowstarttheCommandLine

Interface(CLI)by

•usingadefaultuseraccount,asdescribedin“UsingaDefaultUserAccount”

onpage 1‐6,or

•usinganadministratively‐assigneduseraccountasdescribedin“UsinganAdministratively

ConfiguredUserAccount”onpage 1‐6.

Figure 1-1 D-Series Startup Screen

Connecting Using Telnet

OncetheD‐SeriesdevicehasavalidIPaddress,youcanestablishaTelnetsessionfromanyTCP/

IPbasednodeonthenetwork.Forinformationabou tsettingtheswitch’sIPaddress,referto“set

ipaddress”onpage 2‐9.

ToestablishaTelnetsession:

1. Telnettotheswitch’sIP

address.

2. Enterlogin(username)andpasswordinformationinoneofthefollowingways:

–Iftheswitch’sdefaultloginandpasswordsettingshavenotbeenchanged,followthe

stepslistedin“UsingaDefaultUserAccount”onpage 1‐6,or

–Enteranadministratively‐configuredusernameandpassword.

Thenoticeof

authorizationandthepromptdisplaysasshowninFigure 1‐1.

ForinformationaboutconfiguringTelnetsettings, referto“StartingandConfiguringTelnet”on

page 2‐37.

Username:admin

Password:

Enterasys D-Series

Command Line Interface

Enterasys Networks, Inc.

50 Minuteman Rd.

Andover, MA 01810-1008 U.S.A.

Phone: +1 978 684 1000

E-mail: support@enterasys.com

WWW: http://www.enterasys.com

(c) Copyright Enterasys Networks, Inc. 2006

Chassis Serial Number: 041800249041

Chassis Firmware Revision: 1.0.xx

D2(su)->