Enterasys Networks D2G124-12P Manual

A SERVICE OF

next previous

clear dhcp server statistics

14-10 DHCP Server Configuration

clear dhcp server statistics

UsethiscommandtoclearallDHCPservercounters.

Syntax

clear dhcp server statistics

Parameters

None.

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleclearsallDHCPservercounters.

D2(rw)->clear dhcp server statistics

Configuring IP Address Pools

Manual Pool Configuration Considerations

•ThesubnetoftheIPaddressbeingissuedshouldbeonthesamesubnetastheingress

interface(thatis,thesubnetofthehostIPaddressoftheswitch,orifroutinginterfacesare

configured,thesubnetoftheroutinginterface).

•Amanualpoolcanbeconfiguredusingeitherthe

client’shardwareaddress(setdhcppool

hardware‐address)ortheclient’sclient‐identifier(setdhcppoolclient‐identifier),butusing

bothisnotrecommended.

•IftheincomingDHCPrequestpacketcontainsaclient‐identifier,thenamanualpool

configuredwiththatclient‐identifiermustexistontheswitchin

orderfortherequesttobe

processed.Thehardwareaddressisnotchecked.

•Ahardwareaddressandtype(EthernetorIEEE802)configuredinamanualpoolischecked

onlywhenaclient‐identifierisnotalsoconfiguredforthepoolandtheincomingDHCP

requestpacketdoesnotincludea

client‐identifieroption.

Purpose

ToconfigureandclearDHCPaddresspoolparameters,andtodisplayaddresspoolconfiguration

information.

Note: A total of 16 address pools, dynamic and/or static, can be configured on the D-Series.