FortiGate-400 Installation and Configuration Guide Version 2.50 MR2
FortiGate-400 Installation and Configuration Guide 45
NAT/Route mode installation
This chapter describes how to install your FortiGate unit in NAT/Route mode. To install
your FortiGate unit in Transparent mode, see “Transparent mode installation” on
page 61. To install two or more FortiGate units in HA mode, see “High availability” on
page 75.
This chapter describes:
• Preparing to configure NAT/Route mode
• Using the setup wizard
• Using the front control buttons and LCD
• Using the command line interface
• Completing the configuration
• Connecting the FortiGate unit to your networks
• Configuring your network
• Completing the configuration
• Configuration example: Multiple connections to the Internet
Preparing to configure NAT/Route mode
Use Table 10 to gather the information that you need to customize NAT/Route mode
settings.
Table 10: NAT/Route mode settings
Administrator Password:
Interface 1
IP: _____._____._____._____
Netmask: _____._____._____._____
Interface 2
IP: _____._____._____._____
Netmask: _____._____._____._____
Default Gateway: _____._____._____._____
Primary DNS Server: _____._____._____._____
Secondary DNS Server: _____._____._____._____
Interface 3
(optionally connect
to a DMZ network)
IP: _____._____._____._____
Netmask: _____._____._____._____
