TLS-62xx
Drive 1
Drive 2
Bridge Cable
Terminator
Bridge Cable
{
|
}
~
Filler Plate
Terminator
Bridge Cables
Filler Plate
Figure 4-1 TLS-62xx and 82xx Drive Cabling Diagram
Steps 2 through 4 apply to TLS-62xx and 82xx libraries only.
2. Attach a terminator at connector 6 as shown in Figure 4-1.
3. Connect a SCSI Bridge Cable from connector 2 to the top tape drive as shown at
connector 2 and 3 in Figure 4-1.
4. Connect a Bridge Cable Connector to the top and bottom tape drives as shown at
connectors 4 and 5 in Figure 4-1.
Steps 5 through 10 apply to TLS-54xx/64xx/84xx and either side of 58xxx/68xxx/88xxx
libraries only. Note that if both sides of a58xxx, 68xxx or 88xxx library will have
FCO’s installed, the drive cabling needs to be identical.
5. Refer to the TLS-5000/6000/8000 Installation and Operation Manual (Qualstar
document number 501450) for information about removing the service panel(s)
on the rear of the library.
6. Connect a Bridge Cable Connector to tape drives T1 and T2 as shown at connec-
tors 4 and 5 in Figure 4-2.
7. Connect a Bridge Cable Connector to tape drives T3 and T4 as shown at connec-
tors 8 and 9 in Figure 4-2.
8. Attach a terminator at connectors 6 and 10 as shown in Figure 4-2.
9. Connect the shorter Changer SCSI Bridge Cable from connector 2 to the top tape
drive as shown at connector 3 in Figure 4-1.
10. Connect the longer Changer SCSI Bridge Cable from connector 1 to tape drive
D3 as shown at connector 7 in Figure 4-1.
11. After the SCSI cable connections are complete, see the TLS-5000/6000/8000 In-
stallation and Operation Manual (Qualstar document number 501450) for infor-
mation about reinstalling the service panel(s).
501440 Rev. G 4-2 FCO Type A Installation
